Collingwood Side Bendable Neon Strip Flying Leads, Joiners & End Caps
This range of flying leads, joiners and end caps are specifically designed for use alongside the
standard power and
high power Collingwood side-bendable frosted neon strip lighting. All of these connectors are designed to reach an IP65 rating.
The range of flying lead connectors are designed to be used to supply power to cut lengths of LED strip, with several options available to direct cable in the desired direction to make installation even easier. These flying leads come with 50cm of cable and are available with back, left, right and bottom cable entry.
As the name suggests, the end caps should be used to cap the end of any cut lengths to reach an IP65 rating.
The "strip to strip" joiner is used for connecting two separate lengths of the strip light together to create one solid length. The "strip to 30cm cable to strip" joiner works similarly, however it contains a 30cm length of cable between the connector blocks that allows a break in the light being emitted, which can be useful for combining multiple lengths located near each other to be connected, allowing one power source to power multiple lengths so long as the total combined length does not exceed the maximum run length for the relevant strip light.
Collingwood neon strip flying lead connector w/ 50cm cable - side bend - back entry
Product Code: LDF9372
Collingwood neon strip flying lead connector w/ 50cm cable - side bend - left side entry
Product Code: LDF9374
Collingwood neon strip flying lead connector w/ 50cm cable - side bend - right side entry
Product Code: LDF9376
Collingwood neon strip flying lead connector w/ 50cm cable - side bend - bottom entry
Product Code: LDF9378
Collingwood neon strip end cap - side bend
Product Code: LDF9382
Collingwood neon strip joiner - side bend - strip to strip
Product Code: LDF9392
Collingwood neon strip joiner - side bend - strip to 30cm cable to strip
Product Code: LDF9394