IN-LITE® FLUX 22 Trimless Recessed Lights - 12v

IN-LITE® FLUX 22 TRIMLESS – 22mm Bezel-Free Recessed Uplighter

Ø22mm cut-out | 49° wide beam | Flush, trimless finish

Launched in April 2026, the in-lite® FLUX 22 TRIMLESS delivers the same powerful performance as the standard FLUX 22, but without a bezel. Designed for direct, flush installation into paving, decking or masonry, this trimless version creates a seamless and minimalist lighting finish ideal for contemporary hardscape designs.

Despite requiring just a 22mm diameter cut-out, the FLUX 22 produces a wide 49° beam with a reach of up to approximately 2.5m. This makes it perfectly suited to uplighting walls, façades, statues and architectural details, while maintaining a discreet presence within the surface material.

The absence of a bezel allows the fitting to sit cleanly within the surrounding material, offering a subtle, integrated appearance.

Each in-lite® fitting incorporates a high-quality LED with a 25,000-hour lifetime and is covered by a 5-year warranty when used within the in-lite® system. Supplied with an EASY-LOCK connector, installation to the in-lite® CBL cable is straightforward, with cable extension possible up to 3m using CBL-EXT CORDs.

---

Product Overview:

• Type: Low voltage trimless recessed uplighter
• Finish: Bezel-free design for flush installation
• Beam Angle: 49° wide beam
• Light Reach: Up to approximately 2.5m projection
• Application: Walls, façades, statues, architectural features
• Installation: Recessed mounting with 22mm diameter cut-out
• Compatibility: Standard 12v in-lite® system or 21v SMART HUB-300 system
• Lifetime & Warranty: 25,000-hour LED lifespan; 5-year warranty within the in-lite® system

---

Technical Information:

• Voltage: 12v / 21v low voltage (system compatible)
• Power Consumption: 2VA per fitting
• Beam Angle: 49°
• Cut-Out Diameter: 22mm
• Light Source: Integrated LED
• LED Lifetime: 25,000 hours
• Accessories Supplied: EASY-LOCK connector
• Extension: Cable extendable up to 3m using CBL-EXT CORDs

---

Installation:

• Create a precise 22mm diameter cut-out in the chosen surface.
• Insert the FLUX 22 TRIMLESS fitting so it sits flush with the surrounding paving, decking or masonry.
• Connect to the in-lite® CBL cable using the supplied EASY-LOCK push-fit connector.
• Extend cable length up to 3m using CBL-EXT CORDs if required.
• Ensure alignment is correct prior to final fixing for optimal uplighting effect.

---

Important Notes:

• 5-year warranty valid only when used within the in-lite® low voltage system.
• RING 28 and RING 28 SHIELD bezel versions available for alternative aesthetic or glare-control requirements.
• Ensure total VA load does not exceed transformer capacity when designing the system.