IN-LITE® DISC PENDANT TRIPLE Hanging Light Sets - 12v

Unhide your garden with in-lite®.

Utilising the same light engine as the DISC WALL lights, the low voltage DISC PENDANT hanging lights are a stunning way of softly lighting any outdoor dining table or seating area. For a playful and interesting lighting effect, multiple DISC PENDANT fixtures can be installed together at varying heights. These DISC PENDANT TRIPLE fixtures comes with a 2.2m long cable on each pendant, which can be easily shortened by pulling excess cable up through the base. The DISC PENDANTS should preferably be hung in a windless spot. They are available with only a Black finish.

They are simple to install using the provided screws, cable grommet, secondary aluminium mounting pins and DISC BASE TRIPLE. Instructions for installation can be found on the PDF Installation Guide on this page. They are, of course, also available as a single DISC PENDANT hanging light.

These low voltage pendant lights are compatible with the in-lite® TOUCH DIMMER wall switch which has a choice of 5 brightness levels that can be cycled through, ranging from full brightness to completely turned off.

There is also a mains voltage version of the DISC PENDANT TRIPLE hanging lights available. The 240v version does not require the in-lite® system and as such can be mixed and matched with other lights of your choosing. The mains powered version also features the in-lite® Human Dimming technology that enables dimming of the fixture using just the touch of your hands.

Each 12v in-lite® fitting features an LED with a 25,000 hour lifetime, giving you the peace of mind that they are built to last for years to come. They are covered under warranty for 5 years when used with the in-lite® system. Each light is supplied with one of their EASY-LOCK connectors for easily connecting to anywhere on the chosen in-lite® CBL 12v cable. The fitting is then easily connected to the EASY-LOCK using the push-fit connection. The cable length between the EASY-LOCK and the light fitting can be easily extended by up to 3m using the CBL-EXT cable extensions.

Note: When calculating the total transformer load within an in-lite® system it is crucial to add up the total VA rating rather than the wattage due to power losses. This VA load should not exceed the total stated on the chosen transformer.

Note: Due to the 4.9VA rating for each DISC PENDANT, the DISC PENDANT TRIPLE cannot be used alongside a SPLITTER TRIPLE. Instead, each DISC PENDANT should be connected to its own EASY-LOCK connector located on the two-wire in-lite® system cable.